![]() ![]() ![]()
On
tractors equipped with alternator: Remove approximately 3/16” material from end of adjusting slot in pump bracket butt bracket as shown and re-weld. Grind bracket lower edge to provide alternator fan clearance. Relocation of alternator to provide clearance may be necessary (see photo for position of Delco alternator) |
Installation Steps:
1. Remove old
steering link rod. 2. Install
hydraulic cylinder mounting plate. 3. Install
hydraulic cylinder to mounting plate and front steering arm 4. Install new
steering link rod to hydraulic cylinder and rear steering arm. 5. Install pulley
to hydraulic pump 6. Install
hydraulic pump to top bolt on water pump and adjusting bolt on
generator (note: if converted to alternator, mounting bracket will need
to be reworked as shown below) 7. Install Oil Reservoir to front exhaust manifold bolt. (note: Straighten bend in oil reservoir mounting bracket and fabricate approximately 2” long flat piece |
||
Your comments and suggestions are valuable for us.
sales@powersteeringkit.com
+90 536 3810360